WARNING! It is physically easier to remove the cover using the ratchet wrench than it will be to close the cover. Insert the wrench into the washer and use the wrench to reverse the main tube. Follow the procedure above to remove coupler or clutch bolt and loosen the brakes. On the opposite end of the mechanism is a square hole washer the washer is sized to accept a standard ½” drive ratchet socket wrench. To reduce any possible drag, loosen both brakes completely. Repeat this procedure until the cover is totally retracted keeping the roll as compact as possible. Then roll it up by turning the roller by hand. Slide the cover through the track toward the roller for a few feet on both sides. Manually Uncover the Pool: This requires two people. It may be necessary to remove the lid to accomplish this and to unroll the fabric a little manually before pulling it into the track. Pull ropes equally on either side until the cover is in place. Pull a few feet of rope from the rope reels. Remove the bolt from the coupler or the motor side of the slip clutch, whichever you have. Manually Cover the Pool: This requires two people. Some algicides contain detergent and may damage the cover. You can apply this solution directly on the algae. Make sure you use Clorox, not the pool’s chlorine. Use one (1) part Clorox to nine (9) parts water. Rinse well with fresh water.Īlgae: For algae stains, especially black algae, use a mixture of water and Clorox® bleach. Use the bar soap on a wet cloth and scrub the soiled area. One of the most available non-detergent cleaners is Ivory® bar soap (not dish-washing liquid). Oils and Stubborn Stains: For oils, such as suntan lotion, or stubborn stains that cannot be removed by scrubbing, use a small amount of non-detergent cleanser. Stains: For stains, use a soft bristle brush and scrub the cover with fresh, clean water. Even if the cover does not appear dirty, harmful chemical deposits can accumulate on top of the fabric and can cause premature fabric failure if the fabric is not rinsed regularly. Rinse: Regularly rinse the cover off with a pump in place to remove water and contaminants.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |